Login - Become a member


Forums home -> Rhino -> Help!

post reply

By Eras on Jun 03, 2002 12:17 AM
I'm quite new to Rhino.
My problem is surfaces I make using NetworkSrf command don't match the curves which are made of.
Specially if the surface is intended to be a thin one.
I have rebuilt the curves and surfaces with different point counts and degrees but still they don't match.
I have also changed "Tolerance" options when making the surface.
The only thing that happens is I have a surface with more or less faces.
as can be seen in the pictures below.
Even when I extude a surface from an edge of a surface the extruded surface.

What should I do?
Please help me.
Thanks in advance
Reply with quote
Re: Help! 
By Eras on Jun 03, 2002 12:19 AM
ok I see you cant see the image.........I have post this exactly at cgtalk and have not get any reply yet:
Reply with quote
By root9656 on Dec 14, 2005 02:53 PM
I'm quite new to Rhino.

I believe that this is an event that should be noted in the history books.
Reply with quote

post reply

Page 1 of 1 Go to page: 1
Subscribe to RSS
Follow us on Twitter


Copyright © 1996-2010 Raphael Benedet - Contact Us